The Iris keyboard, a split ergonomic keyboard with 4x6 vertically staggered keys and up to 4 thumb keys. Time to stop stretching your thumbs out on the Ergodox!
Differences with Rev. 7
The differences between this Rev. 7 PCB and the Rev. 6 PCB are the following:
- 2u thumb support has been re-added in Rev. 7
- Additional encoder option has been added to outer top corners
- I2C breakout pads added to each half
Iris PCBs with on-board controller and USB-C port. Just put in your switches and you're done! The rotary encoder pins are not hotswapped, so encoders need to be soldered in if installing them.
- Left half PCB
- Right half PCB
Two colors are available:
Items Needed for Build
- Iris PCBs (this item)
- Iris Plate Kit
- USB-C to USB-C Cable to connect both halves together
- Iris middle layer (optional)
- 54-56 Switches (MX only)
- USB-C Cable to connect to computer
- Rotary Encoder and knobs (optional)
- Silicone Hotswap Bumpers (optional, but recommended)
- SKUF Keyboard Feet (optional)
- 3D-printed case to supplement plates (optional)
- Available at Tree Dog Studio
Rev. 7 Features
- On-board ATmega32u4 controller
- Switch support: MX-compatible only
- USB-C port
- MX Hotswap sockets pre-installed
- 6 RGB underglow LEDs per half (12 total)
- Per-key RGB LEDs
- Option for rotary encoders at upper thumb key and outer top corners on each half
- Pre-flashed with QMK Firmware and VIA configurator support
Each half of the board is a 4x6 matrix with the same vertical stagger as the Ergodox and with 2-4 thumb keys. Alternatively, a rotary encoder can be placed at the upper thumb key of each half.
Many thanks to Lewis Ridden (/u/GAMING_FACE) for coming up with this design.
The Iris uses QMK for its firmware, and the code for it is here: QMK - Iris directory.