Dilly - 3x10 Ortholinear Keyboard Kit

• 3x10 grid of keys
• In-switch LED support
• Breakout pins for adding RGB strips
• Default Layout: Dilly KLE

• 1 PCB
• 1 Bottom plate
• 12 4mm M2 screws
• 6 5mm M2 standoffs
• 2 SKUF Feet
• Pre-soldered reset switch, diodes, and resistors

Dilly Build Guide

Pre-compiled firmware for a variety of microcontrollers can be found in the build guide here: Dilly Firmware

This firmware uses the popular open-source QMK Firmware with VIA enabled out of the box to allow you to remap all the keys just the way you want them.

Plug your keyboard in, open up the VIA app, and easily change what each key does to get the most out of your keyboard with your customizations! More info on what you can do here: VIA Usage Guide

ZMK Config

• Shield setup for ZMK can be found in this config: ZMK Dilly Shield

• Kailh Choc V1 low-profile switches
• Keycaps for Kailh low-profile switches
• 1 microcontroller
• 1.8mm or 2x3x4mm LEDs (optional)
• RGB strip for underglow (optional)

Default Keymapping

The default keymapping that the board is pre-programmed with can be found here: Default Keymaps

Firmware Builds

You can find pre-compiled firmware QMK builds with VIA enabled for the Dilly here for some microcontrollers:

• RP2040 Pro Micro Firmware
• Elite-Pi Firmware
• ATmega32u4 Pro Micro Firmware

ZMK Config

Shield setup for ZMK can be found in this config: ZMK Dilly Shield