There was an error signing up for restock notifications. Please try again.
Top/bottom plates for the Levinson keyboard. The middle layers are optional and can be added in between the top and bottom plates at any time (stainless steel and acrylic plate versions only).
These plates are backwards-compatible with the Let's Split v2, if you want to use it with those PCBs.
Plates for the Levinson are offered in these variants:
These plates are made from 1.6mm PCB material (FR-4)
Plates w/interior screws - screws are hidden, and when the two halves are placed next to each other, it looks like a Planck
Plates w/exterior screw - same design as the stainless steel plates
The flex is comparable to 3mm acrylic
16 gauge (1.56mm) 304 stainless steel with a #4 finish
Note that the backside of each plate may have scratches on it, but they are hidden when the board is assembled
Aluminum PCB plates
Top side is black
Back side is raw aluminum, and may have scratches and dings (i.e. not suitable for use on this side)
Exterior screw design
3mm thick plates, available in black or white
The plates come with the following:
2 Switch plates
2 Bottom plates
For the PCB plates w/interior screws:
16 M2 6mm screws
8 M2 11mm standoffs
For the stainless steel, acrylic, and PCB plates w/exterior screws:
32 M2 6mm screws
16 M2 11mm standoffs
Switch plates are compatible with MX and Alps switches and support MX switch top removal. Note that for the non-1u cutouts however, the switches won't have anything on the plate to grab on to, so you need to be careful with alignment when soldering the switch.
This middle layer is used to enclose the keyboard. For now, a clear acrylic layer will be offered that's compatible with the stainless steel, acrylic, and PCB plates w/exterior screws.
There are 2 different types of middle layers available:
W/tenting support - has 4 side holes to accept 1/4" or M6 screws to tent the board
The middle layers come with 2 10mm thick pieces and 2 2mm thick pieces. If you remove the plastic from the Pro Micro headers, you can just use the 10mm pieces alone on each side. If you leave them on, you'll need to use a 10mm piece in conjunction with a 2mm for a total of 12mm of thickness.
Note: This is not compatible with the PCB plates with the interior screws.